CapeClock Administration Page
Most of these functions below are intended for Clock
Administrators. Using these functions may result in a loss of data from
the clock. Please be careful.
Flash Updating
1) Before flash updating your fox, you will need to know the serial
number of this device.
View Current Serial Number.
Please write this number down.
2) Close down running
Clock Applications
Please note:
- The process will delete all the data on the FOX board.
- After pressing "Upgrade", the transfer process will start.
It takes a couple of minutes (and doesn't show anything in your browser
for a while).
- Do NOT close the browser, nor press
"Back" or "Stop".
- Do NOT reset or turn off the clock. The
clock will restart automatically after upgrade is completed.
- The IP address of your clock after flashing should be 10.0.20.40 (admin page)
4) Set
Serial Number (NB: This must be set to the same Serial Number
that you wrote down in step 1)
5) (Optional) Set
IP Address
(Please make sure any new settings
are 100% correct before saving them -
otherwise your clock may fail to boot)
6) Reboot
Other Functions
System Restore