CS TimeClock USB Firmware Update instructions
---------------------------------------------

1. Extract release_xxxx.zip (xxxx is the version number e.g. the filename for release 1.14f will be release_114f.zip) downloaded from the www.cstimeclock.com website.

2. Copy the \release folder and the contained files to the root of your USB Thumb drive e.g. after copying the folder, if the drive letter of your thumb drive is E:, the path will be: E:\release.  

3. E:\release must contain the following files:  
	new.sh
	new.tar.gz
	new.txt

4. Plug the thumb drive into an available USB port on the clock.

5. Enter 961#.

6. Enter the supervisor / administrator card number followed by the # key.

7. The clock will check the USB thumb drive and compare the firmware versions.  
   a. If the firmware on the thumb drive is a later version, the update will proceed and the clock will reboot.  The update should be done in about 3 minutes.  
   b. If the firmware on the clock is the same or a later version than the one on the thumb drive, the clock will display:  “No update needed”.  
   c. The clock will displayed “Failed” if there’s a problem with the files or the file location on the thumb drive.